The installation of your hot water system, either electrical system or a gas heater, is intended to provide a consistent and reliable supply of hot water for your home.
There are numerous tiny things that are typically forgotten when installing or replacing hot water systems, so we’ve compiled a list of 5 common mistakes to avoid.
While it may be tempting to tackle your house water heater on your own, it is best to enlist the help of a professional plumber in Pimpama or an electrician. To ensure that the task is done the first time correctly, it is advisable to use an experienced and vetted plumber like Moyle Plumbing for installing a new hot water system or for hot water replacement.
Do you want to install a hot water system? Don’t Make These 5 Mistakes?
Many homeowners make frequent mistakes during installation or replacement that cause the water heater to perform inefficiently and, in some cases, have disastrous consequences that are difficult to correct.
-
Purchasing an insufficiently sized hot water system
Many homeowners purchase water heaters that are simply not the proper size for their needs. A standard two-and-a-half shower bath requires 50 gallons of hot water; however, depending on your needs, the best-fit model should be chosen.
It will not only help you save money on both the original and ongoing costs, but it will also ensure that you are never without hot water when you need it. Purchasing a too large system, on the other hand, wastes money, water, and time. As a result, you’ll need expert advice on the best hot water system for your needs.
-
Fittings Soldered Directly On The Water Heater
A common D-I-Y mistake while installing or replacing a water system is soldering the fittings tightly close to the tank. To stop the heat from melting the dip-tube or any of the plastic fittings and causing major damage to the water heater, unscrew the nipples and solder on the fittings individually away from the water heater. If you’re unsure how to do this, contact a company like Flow Pros Plumbing for help.
-
Metal Pipes That Aren’t Compatible
Did you know that when installing a new hot water system or replacing a hot water system, you must pay particular attention to the compatibility of two metal pipes?
If your tank has brass or copper connectors and your house’s pipes are copper, water heater installation will be relatively simple. If your home’s pipes are galvanized steel, a qualified plumber in Pimpama, such as those at Moyle Plumbing, will always use a dielectric union to prevent these two pipes from colliding and creating an electric and corrosive charge, which might damage the pipe and cause leaks.
-
Dry Combustion
It’s critical not to turn the circuit on until the water heater is entirely filled with water after you’ve installed it or finished gas hot water repairs. Once your hot water system is installed, make sure you purge all of the air out of the tank by opening the hot water faucet and waiting until you get a continuous flow of water. The water heater can then be turned on. It’s crucial because dry firing a water heater, whether electric or gas, can cause the tank to overheat, shatter, and potentially damage the heater.
